Hi, this is Rett Rasmussen with Rasmussen Gas, Logs and Grills and I'd like to tell you about our Burner Kits. In our Gas, Log Burner Kits, we use a five-eighths-inch grate where the teeth are welded on the diamond. This gives amore massive appearance than what the industry standard is, which is half-inch welded on the flat. We also make our burner pans out of 16 gauge cold rolled steel and our burner tube pipes out of Schedule 40 pipe. Not light duty tubing, not light duty 18 and even 20 gauge steel that some competitors use. We weld all the seams for gas tight integrity and on some of our burners, like our FX Burner, we add in the smaller amber booster tubes that distribute the gas across a wider area, giving you a larger, more radiant amber bed than what you get off of just a traditional burner that does not have that extra burner tubes. One other feature we have in our burners is we thread both internally and externally, both ends of the burner pipe, so that gives you maximum flexibility for your installation. Depending on what your situation is, we've got you covered. Some of our burners, like our LC Burner, have multiple burners welded to the grate. This provides for more distribution of the gas in different areas. You have your amber bed area and then you have your main flame area. It's a very efficient use of the gas because you're not spending it on that four inches trying to go from the floor up to the top level of the grate. With each of our sets, we provide a ...
Keywords: rasmussen, vented, gas, logs, burner, kit
0 comments:
Post a Comment